Kit Stator 200w + Cdi Box + External Ignition Coil For Honda Xr 600 R 1990 1991
Highest grade of lamination materials. Higher grade of electronic components. No stator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. ALWAYS START WITH A FULLY CHARGED BATTERY! Brand new Kit High Output Stator 200W + High Performance CDI + External Ignition Coil. All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part. Brand new aftermarket High output Stator 200W. Highest grade of copper winding, resistant to 200 degrees Celsius. We have even included the opposite connector (main harness side) as we know these are often melted / corroded / defective and a major cause of repetitive electrical issues. Brand new aftermarket CDI box. Enhanced timing curve, increased rev limiter (approximately 1000 rpm). The quality exceeds the OEM equipment.
Dimensions: Interior diameter: 54 mm Exterior diameter: 115 mm Thickness: 15 mm Length of wires stator to grommet: 200 mm Length of wires grommet to plug: 700 mm. Other specifications: Number of wires: 5 Number of plugs: 5 Number of pins: 3 Number of poles: 17 Wire to wire resistance: Alternator: White to Green = 0.4 ohms +-20% Alternator: Yellow to Red = 0.4 ohms +-20% Source: Black/Red to Green = 140 ohms +-20%.
Dimensions: Height: 22mm Length: 66mm Width: 42mm. Other specifications: Number of plugs: 2 Number of pins: 6. Please note that: The only real way to test your CDI box is to swap it out with another known good unit from the same year/make/model.
Because of this, we recommend that you rule everything else out before replacing the CDI box. Before installing your new Stator.
Check the AC output of the stator. Replace any burned or corroded connectors on stator and regulator rectifier. Check and repair any melted wiring. Use hi-temp dielectric grease on all connectors.
Our stator might have a different wire color code than your original part. All the wires are installed in the correct order; please do not change any of the wiring configurations. This stator is designed as a direct plug-in replacement and should be used as such. When bolting stator in, always use locking compound.
Before installing your new CDI. Our CDI may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations. This CDI is designed as a direct plug-in replacement and should be used as such. Before installing your new External ignition coil. Remove spark plug cap(s) from your OEM external ignition coil.
Screw cap(s) on the new external ignition coil. More than 20 years of assisting mechanics around the world resolving the worst electrical problems made us know our stuff. When it comes to vehicle electrics, we definitively are the power in powersports. This item is in the category "Automotive\Parts & Accessories\Motorcycle Parts\Other Motorcycle Parts".
- Brand: RMSTATOR
- Manufacturer Part Number: RMS900-107583--M--H
- Warranty: 2 Year