Kit Ho Stator + Cdi Hp + Ignition Coil + Flywheel Oem Repl. # 2gu-85550-50-00

Submitted by admin on Mon, 05/30/2022 - 14:24

Kit HO Stator + CDI HP + Ignition Coil + Flywheel OEM Repl. # 2GU-85550-50-00

ATV / UTV / SXS. Brand new Stator + CDI box HP + External Ignition Coil + Flywheel Kit. The quality exceeds OEM equipment.

Direct replacement to your original unit. Plug-and-play, direct fit, easy installation. Brand new Stator + CDI Box HP + External Ignition Coil + Flywheel Kit. All item pictures are accurate; if in doubt, do not hesitate to compare our item to your original part. Highest grade of lamination materials.

Highest grade of copper winding, resistant to 200 degrees Celsius. Our part is a Plug-and-play unit, direct fit, and easy to install. Enhanced timing curve, increased rev limiter (approximately 1000 rpm).

Higher grade of electronic components. The Quality exceeds the OEM equipment.

Spark plug cap(s) included. RMSTATOR is offering a new replacement flywheel with stronger magnets for your Suzuki and Kawasaki, this flywheel can be used as a direct replacement to the OEM.

We suggest combining it to our 100 or 200 watt stator as it will run the lights better in the lower rpm's. Please note that: The only real way to test your CDI box is to swap it out with another known good unit from the same year/make/model.

Because of this, we recommend that you rule everything else out before replacing the CDI box. Flywheel Dimensions : Exterior Diameter: 128 mm Interior diameter : 105 mm Interior Diameter Center Housing: 21 mm Exterior Diameter Center Housing: 34 mm Thickness (exterior) : 12 mm Thickness (interior): 7 mm External Ignition Coil Bracket center to bracket:: 90 mm Wires length: 590 mm Primary Resistance: 0.4? Secondary Resistance: 6.0 K? Spark plug cap Resistance: 5 K Voltage Transfer Ratio: 150:1 Insulation Resistance: >1000 M. Before installing your new stator. Check the AC output of the stator. Replace any burned or corroded connectors on stator and regulator/rectifier. Check and repair any melted wiring. Use hi-temp dielectric grease on all connectors. Our stator may use a different wire color code than your original.

All of the wires are installed in the correct order; please do not change any of the wiring configurations. This stator is designed as a direct plug-in replacement and should be used as such. When bolting stator in, always use locking compound. CDI Box HP Our CDI may use a different wire color code than your original. This CDI is designed as a direct plug-in replacement and should be used as such.

Before attempting to start your banshee adjusting the air gap is necessary. Remove the yellow wire from the external ignition coil, if it is not applicable to your model. More than 20 years of assisting mechanics around the world resolving the worst electrical problems made us know our stuff.

When it comes to vehicle electrics, we definitively are the power in powersports. This item is in the category "Automotive\Parts & Accessories\ATV, Side-by-Side & UTV Parts & Accessories\Electrical Components". The seller is "rmstator-canada" and is located in this country: CA.

This item can be shipped worldwide.